Professional made-to-measure digital sewing patterns — PDF · PLT · DXF AAMA
A hip-length, fully lined women's jacket with an asymmetric front: the right front laps diagonally over the left and fastens with buttons through a placket. A shawl-shaped collar, folded pleats at the side of the right front and two-piece set-in sleeves. Drafted to your own measurements. Recommended fabric: fine suiting fabric from natural or blended fibres.
A hip-length, fully lined women's jacket with an asymmetric front: the right front laps diagonally over the left and fastens with buttons through a placket. A shawl-shaped collar, folded pleats at the side of the right front and two-piece set-in sleeves.
Silhouette: Fitted, shaped by princess seams and darts on the back and a bust dart on the left front.
Length: Hip length; the lapping right front ends in a slanted corner at the hem.
Collar: Separate shawl-shaped collar, cut as upper and under collar, each with a centre back seam; the outer collar is interfaced.
Sleeves: Long two-piece set-in sleeves with an eased cap; shoulder pads and sleeve heads.
Front: Asymmetric. A placket, folded in half, is stitched to the right front edge and carries the buttonholes; buttons are sewn on the left front. A third button inside holds the left front in place. Pleats on the right front at the side are stitched and pressed downwards.
Back: Centre back seam, princess seams from the armhole and darts.
Finishing: Hem and sleeve hem allowances 3.5 cm, interfaced.
Lining: Full lining with lined sleeves, attached to the facings and hems; the jacket is turned through an opening in the right lining sleeve.
Intermediate. An asymmetric front with a buttonhole placket and separate left and right facings, a two-layer collar, two-piece sleeves with an eased cap and a bagged lining.
Fine suiting fabric from natural or blended fibres.
From main fabric:
From lining fabric:
The lining Center Back and the lining Left and Right Fronts are cut minus the width of the Back Neckline Facing and the Center Front Facings respectively.
From fusible interfacing: Placket, Left and Right Center Front Facing, Back Neckline Facing, outer Collar (2 pieces), plus strips for the jacket hem and sleeve hem allowances.

#4304
Jacket with High-Low Peplum
#4301
Wrap Front Peplum Jacket

#4305
Leather Jacket with Front Zip

#4308
Tailored Jacket with Mock Double Welt Pockets

#4309
Fitted Paneled Jacket with Flap Pockets

#4296
Stand Collar Zippered Leather Jacket

#4328
Double Breasted Jacket with Wide Lapels

#4329
Fitted Collared Jacket With Sleeves

Minerva Support
Online