V-Neck Dress With Puffed Sleeves
A knee-length women's straight dress with a slit V at the centre front of a round neckline, short sleeves with a smooth upper part and a gathered, lined puff, and a back vent. It is worn with a separate wide waistband in contrast fabric that fastens with hooks and is wrapped with a narrow tie.
When To Wear
- Office and daytime meetings in spring and summer.
- Lunches and family celebrations, with the contrast waistband marking the waist.
Key Design Features
Silhouette: Straight, close to the body, shaped with bust, waist and shoulder darts on the front and back.
Length: Knee length.
Neckline: Round neckline with a narrow slit at the centre front, finished with an interfaced front and back facing.
Sleeves: Short set-in sleeves in two parts: a smooth upper sleeve and a lower sleeve gathered along both edges, faced with lining at the lower edge so it forms a puff above the elbow.
Closure: Concealed zipper at the top of the centre back seam.
Back: Centre back seam with a lapped vent at the hem.
Waist: Separate wide waistband (Waistband 1) in contrast fabric, interfaced, fastened with 3 concealed hooks and eyes; a long narrow tie (Waistband 2) in the same fabric is wrapped over it and knotted at the front.
Finishing: Hem sewn by hand with blind stitches.
Lining: The dress is unlined; only the lower sleeves are lined.
Level Of Difficulty
Intermediate. A faced neckline slit trimmed close to the stitching, a lapped back vent, a concealed zipper and two-part sleeves with a lined gathered puff.
Fabric Recommendations
Dress fabrics made from natural or blended fibres; a contrast or companion fabric for the waistband and tie.
Additional Supplies
- Lining fabric (lower sleeves)
- Concealed zipper
- Fusible interfacing (neckline facings, waistband, tie, back vent)
- 3 concealed hooks and eyes
Cutter's Must
From main fabric:
- Back – 2 pieces
- Front – 1 piece
- Upper Sleeve – 2 pieces
- Lower Sleeve – 2 pieces
- Front Neckline Facing – 1 piece
- Back Neckline Facing – 2 pieces
From contrast fabric:
- Waistband 1 – 1 piece
- Waistband 2 – 1 piece
From lining fabric:
- Lower Sleeve Lining – 2 pieces
From fusible interfacing:
- Front Neckline Facing – 1 piece
- Back Neckline Facing – 2 pieces
- Waistband 1 – 1 piece
- Waistband 2 – 1 piece
Sewing Instructions
- Fuse interfacing to the neckline facings and to Waistband 1 and Waistband 2.
- Stitch darts on back and front pieces. Press the waist and shoulder darts towards the center of the pieces and the bust darts upwards.
- On the left Back, trim 5 cm off along the vertical edge of the vent extension. Fuse interfacing to the vent area on the wrong side of both Back pieces. On the right side, mark the center seam line (vent fold line). On the left piece, press the vent along the fold line; on the right piece, press only the vent allowance (6 cm) to the wrong side. Align the pieces along the center seam and baste them together at the upper edge of the vent. Overlock the vent allowances. Stitch the center back seam from the mark to the vent corner. Clip into the corner of the vent allowance on the right piece. Press the center seam allowances open and overlock them; press the vent allowances and secure them from the right side with machine stitching. Insert the invisible zipper.
- Stitch the side and shoulder seams, press allowances towards the back and overlock.
- Stitch the shoulder seams of the facings, press the allowances open. Overlock the outer edge. Place the dress and facing right sides together, aligning the neckline edges. Stitch the neckline and the front slit. Clip allowances on curves, trim at corners, and along the front slit trim the allowance to 0.1–0.2 cm. Turn pieces to the right side, straighten and press. Attach the facing to the shoulder seams and zipper tape.
- Stitch the sleeve seams of the main fabric pieces and of the Lower Sleeve Lining, press the allowances and overlock. Run lines of long, loose stitches along the lower and upper edges of the Lower Sleeve and gather. Place the Lower Sleeve and Lower Sleeve Lining right sides together and stitch the lower edge. Turn right side out, match the edges and baste the lining to the main fabric along the upper edge and the sleeve cap edge. Handle them as one piece from now on.
- Stitch the Upper Sleeve to the Lower Sleeve, press allowances upwards, overlock. Set in the sleeves into the armhole, matching notches. Press and overlock allowances.
- Overlock the hem allowance of the dress, press to the wrong side and hem with blind stitches.
- Fold Waistband 1 in half lengthwise, right sides together, and stitch along three sides, inserting the hooks into one of the short ends, and leaving an opening on the long side for turning. Turn right side out and press. Close the turning opening. Adjust the waistband length and sew on the eyes for the hooks.
- Fold Waistband 2 (tie) in half lengthwise, right sides together, and stitch along three sides, leaving an opening on the long side for turning. Turn right side out and press. Close the turning opening.