Professional made-to-measure digital sewing patterns — PDF · PLT · DXF AAMA
A fitted, hip-length women's jacket for dense knit fabric, with a shawl collar cut in one with the fronts, front and back princess seams and a two-button front. All outer edges are bound with contrasting knit binding instead of hemmed. Drafted to your own measurements. Recommended fabric: dense knit fabrics of natural or blended fibres.
A fitted, hip-length women's jacket for dense knit fabric, with a shawl collar cut in one with the fronts, front and back princess seams and a two-button front. All outer edges are bound with contrasting knit binding instead of hemmed.
Silhouette: Fitted, shaped by princess seams on the front and back.
Length: Hip length, with rounded front corners at the hem.
Collar: Shawl collar cut in one with the centre front pieces and joined by a seam at the centre back; the collar on the facing is built the same way.
Sleeves: Long, two-piece set-in sleeves (upper and lower sleeve), cap eased into the armhole, lower edge bound.
Closure: Single-breasted, two buttons with buttonholes on the right front.
Pockets: Two patch pockets with rounded lower corners, topstitched onto the fronts, upper edge bound.
Back: Centre back seam, princess seams and a dart on each centre back piece.
Finishing: Front edges, collar and hem bound with contrasting knit binding through the jacket and facing together (no seam allowance on these edges); fusible stay tape along the back neckline; thin shoulder pads.
Lining: Unlined; the fronts and back neckline are finished with interfaced facings.
Intermediate. Princess seams, a two-piece set-in sleeve, a shawl collar set into the back neckline with clipped corners, and continuous binding of curved edges in knit fabric.
Dense knit fabrics of natural or blended fibres.
If the patterns have a double contour, seam allowances are included. If the contour is single, seam allowances are not included. Seam allowances: all seams – 1 cm. Allowance at the front edge, at the top of the pocket, and at the hem of the garment and sleeve – 0 cm. Attention! First, print out the paper patterns and lay them out on the fabric width (fabric width can be from 90 cm to 150 cm) to determine how much material you will need (remember to account for paired and symmetrical pieces). When stitching pieces, pay attention to the notches – they must match!
From main fabric:
From knit fusible interfacing:

#4475
Tailored Collarless Shaped Jacket

#4433
Fitted Draped V-Neck Jacket

#4423
Fitted High Collar Asymmetrical Scalloped Jacket

#4415
Pleated Front Coat With Stand Collar

#4526
Short Sleeve Asymmetric Rounded Collar Jacket

#4530
Lined Tailored Jacket With Zipper Pockets

#4542
Fitted Collared Long Sleeve Blazer

#4575
Collared Jacket with Cuffed Three Quarter Sleeves

Minerva Support
Online