Professional made-to-measure digital sewing patterns — PDF · PLT · DXF AAMA
A women's sleeveless fitted top for knit fabric, hip length, with a draped front neckline formed by pleats and framed by wide shaped bands that run over the shoulders as straps. Drafted to your own measurements. Recommended fabric: knit fabric with medium or low stretch, of natural or blended fibres.
A women's sleeveless fitted top for knit fabric, hip length, with a draped front neckline formed by pleats and framed by wide shaped bands that run over the shoulders as straps.
Silhouette: Close-fitting, straight, for knit fabric with medium to low stretch.
Neckline: Front upper edge turned under and topstitched, then laid in pleats by the markings so it falls in soft folds; round back neckline.
Front: Centre front panel set between two shaped front bands; the bands form the shoulder straps and continue down the front to the armhole.
Sleeves: Sleeveless; armholes turned under and topstitched.
Back: One piece, plain.
Finishing: All edges serged, turned to the wrong side and topstitched; the hem with a twin needle to keep its stretch.
Beginner. Three pattern pieces, a few pleats and straight seams in knit fabric; the only fiddly step is joining the front to the bands at the clipped notch.
Knit fabric with medium or low stretch, of natural or blended fibres.
If the patterns have a double contour, seam allowances are included. If the contour is single, seam allowances are not included. Seam allowances: allowance for the hem of the garment, Back neckline edge, upper edge of the Front, Back and Front armhole edges, Front Placket edge from the shoulder seam to the mark – 1.5 cm, other seams – 0.7 cm. Attention! First, print out the paper patterns and lay them out on the fabric width (fabric width can be from 90 cm to 150 cm) to determine how much material you will need. When stitching pieces, pay attention to the notches – they must match!
From main fabric:
Tip: Knit fabric pieces are stitched with a special elastic or narrow zigzag stitch. When serging, trim seam allowances to 0.8 cm. The hem allowance is topstitched with a twin needle to maintain elasticity. You can also stitch pieces directly on a 3- or 4-thread overlocker.
#4018
Gathered High Neck Blouson Top

#4042
Knit Top with Crossover Folded Collar
#4051
Top with Ruched Waistband & Back Wrap
#4070
Knit Turtleneck with Empire Seam
#4096
Knit Collared Wrap Top with Long Cuffed Sleeves

#4098
Jersey Top with Front Gathers
#4105
Asymmetrical Pleated Long Sleeve Top

#4119
Cowl Neck Knit Top with Banded Hem

Minerva Support
Online