Oversized Collar Capelet

CUTTER'S MUST

• From main fabric:
1. BACK PANEL - 1 QTY
2. FRONT PANEL - 2 QTY
3. Upper COLLAR – 1 QTY
4. Lower COLLAR – 2 QTY
5. FACING – 2 QTY
6. BACK neckline FACING – 1 QTY
• From LINING fabric:
1. BACK PANEL - 1 QTY
2. FRONT PANEL - 2 QTY

ATTENTION: FRONT PANEL and BACK PANEL LINING pieces are cut without considering the width of the FACINGS and the BACK neckline FACING, respectively.

From FUSIBLE INTERFACING: FACINGS, BACK neckline FACING.

Sewing Instructions

1. Fuse FUSIBLE INTERFACING to the FACING pieces and the BACK neckline FACING.
2. Stitch the center seam of the lower COLLAR. Press SEAM ALLOWANCES open. Create and baste pleats on the upper COLLAR piece. Place COLLARS right sides together and stitch along the outer edge. Turn right side out, baste, and press.
3. Stitch the shoulder seam.
4. Stitch the shoulder seams of the FACINGS and the neckline FACING. Press SEAM ALLOWANCES open. Place FACINGS right sides together with the FRONT PANEL, insert the COLLAR between them, and stitch along the front edge and neckline. Stitch the shoulder seams of the LINING pieces, leaving an opening unstitched for subsequent turning. Attach the LINING to the FACINGS and the neckline FACING. Stitch the bottom corner. Clip SEAM ALLOWANCES on curves, trim corners. Mark and press the hem of the cape to the wrong side. Finish the bottom of the garment with the LINING. Turn the cape right side out, baste, and press. Close the technological opening.
5. Stitch a topstitch 1 cm from the edge along the front edge and the bottom of the garment.
6. Sew a hook to the right FRONT PANEL, and a loop to the left FRONT PANEL.