CUTTER'S MUST
- From main fabric:
- FRONT PANEL - 1 QTY
- BACK PANEL - 1 QTY
- SLEEVE - 2 QTY
- BACK NECKLINE FACING – 1 QTY
- FRONT NECKLINE FACING – 1 QTY
- For gathered variations, the following additional pieces are introduced:
- FRONT CASING – 2 QTY
- SLEEVE CASING – 2 QTY
- BACK CASING – 2 QTY
Fabric & Materials
FROM FUSIBLE INTERFACING: FRONT NECKLINE FACING, BACK NECKLINE FACING.
TIP: To ensure the material remains stretchy in the areas with seams, stitch the cut pieces with a narrow zigzag or a special stretchy stitch. To keep the bottom edge stretchy, the hem should be overlocked with an overlock stitch, then stitched using a twin needle. This also applies to finishing other edges of the garment that should not lose elasticity. These recommendations do not apply to industrial production.
Sewing Instructions
- Fuse the FRONT NECKLINE FACING and BACK NECKLINE FACING with FUSIBLE INTERFACING.
- Stitch the FRONT NECKLINE FACING and BACK NECKLINE FACING together. Overlock the FACINGS.
- Stitch the shoulder seams, inserting a selvedge into the shoulder.
- Finish the neckline of the FRONT PANEL and BACK PANEL with the FACINGS.
- Topstitch the neckline FACINGS of the FRONT PANEL and BACK PANEL.
- Stitch the side seams.
- Stitch the SLEEVE seams.
- Set in the SLEEVES, easing the cap.
- Hem and topstitch the bottom of the SLEEVE and the garment.
- For gathered variations, the following changes are introduced:
- Hem and topstitch the bottom of the SLEEVE and the garment.
- Place each casing strip from the lining fabric onto the wrong side of the blouse or SLEEVE according to the markings, turn back the lower end of the strip. Baste the strip from the right side to the blouse, then topstitch along the markings.
- Fold each strip lengthwise and stitch at a distance of 0.7cm from the fold. Turn the tie right side out and press. Stitch the ends closed. Thread the ties into the casing. Gather the fabric onto the ties, distribute the gathers, and tighten the ends of the ties.
