Professional made-to-measure digital sewing patterns — PDF · PLT · DXF AAMA
A fitted women's jacket with princess seams front and back, a wide collar cut in one with the fronts, a four-button front, flap pockets and a hem rounded off at the front edges. Fully lined. Drafted to your own measurements. Recommended fabric: suiting fabrics of natural or synthetic fibres.
A fitted women's jacket with princess seams front and back, a wide collar cut in one with the fronts, a four-button front, flap pockets and a hem rounded off at the front edges. Fully lined.
Silhouette: Close-fitting, shaped at the waist by princess seams.
Length: Hip length; the front edges curve away into a rounded hem.
Collar: Wide collar cut in one with the front, joined by a centre back collar seam and set into the back neckline; it stands away from the neck above a V opening.
Sleeves: Two-piece set-in sleeves with shoulder pads.
Closure: Single-breasted, four buttons and buttonholes.
Pockets: Jetted pockets with flaps on the side fronts.
Back: Centre back seam and princess seams from the armholes.
Finishing: Front edges, neckline and hem faced; separate front and back hem facings; interfacing on the centre fronts, facings, upper back at the armholes and sleeve hems.
Lining: Full lining cut in the jacket panels, turned through an opening in the right sleeve seam.
Advanced. A cut-on collar turned at a clipped neckline corner, jetted flap pockets, faced curved hem, two-piece sleeves with shoulder pads and a full lining.
Suiting fabrics of natural or synthetic fibres.
If the patterns have a double contour, seam allowances are included. If the contour is single, seam allowances are not included. Seam allowances: Hem allowance for sleeve bottom edge 3 cm, all other seams – 1 cm. Attention! First, print out the paper patterns and lay them out on the fabric width (fabric width can be from 90 cm to 150 cm) to determine how much material you will need (don't forget to account for paired and symmetrical pieces).
From main fabric:
From lining fabric:
Lining pieces for front and back are cut deducting the width of the neckline facing, hem facing, and front facing.
From fusible interfacing:
Also interfaced: upper of center back with armhole section, armhole of side back, hem allowance for sleeve bottom edge.
When stitching pieces, pay attention to the notches - they must match!

#4968
Hooded Parka Drawstring Waist Fishtail Hem

#4973
Leather or Faux Leather Jacket

#4963
Asymmetrical Zipper Jacket

#4978
Round Neck Zipper Front Peplum Jacket

#4979
Zip Front Peplum Jacket

#4960
Moto Jacket Asymmetrical Zipper Contrast Panels
#4981
Lapel Jacket With Drawstring 3/4 Sleeves

#4982
Rounded Collar Double-Breasted Jacket

Minerva Support
Online