Professional made-to-measure digital sewing patterns — PDF · PLT · DXF AAMA
A women's knee-length sheath dress in low-stretch knit with an asymmetric front: pleats gathered towards a side-front seam, a tab with a buckle at the waist and a slit below it. Elbow-length set-in sleeves and a zip at the centre back. Drafted to your own measurements. Recommended fabric: low-stretch knit of natural or blended fibres.
A women's knee-length sheath dress in low-stretch knit with an asymmetric front: pleats gathered towards a side-front seam, a tab with a buckle at the waist and a slit below it. Elbow-length set-in sleeves and a zip at the centre back.
Silhouette: Fitted sheath, slightly narrowing towards the hem.
Length: Knee length.
Neckline: Round neckline with an interfaced facing, topstitched along its outer edge.
Sleeves: Set-in, elbow length, with a 2 cm topstitched hem.
Front: Cut in two parts: a centre front with darts and pleats turned towards the middle, and a narrow side front. The seam between them opens into a topstitched slit in the skirt.
Closure: Zip in the centre back seam.
Back: Centre back seam and princess seams on both back halves.
Waist: A shaped self-fabric tab is caught in the side seam, passed through a decorative buckle and stitched into the side front seam.
Finishing: Hems turned up 2 cm and topstitched with a twin needle or on a coverstitch machine.
Intermediate. An asymmetric front with pleats and a slit set into a seam, a zip in knit fabric, a neckline facing.
Low-stretch knit of natural or blended fibres.
If the patterns have a double contour, seam allowances are included. If the contour is single, seam allowances are not included. Seam allowances: allowance for the hem of the garment and sleeve hem – 2.0 cm, other seams – 1 cm. Attention! First, print out the paper patterns and lay them out on the fabric width (fabric width can be from 90 cm to 150 cm) to determine how much material you will need. When stitching pieces, pay attention to the notches – they must match! The inscriptions on the patterns are made on the right side!
From main fabric:
From fusible interfacing:
Tip: Cut pieces from knit fabrics are stitched with a special elastic or narrow zigzag stitch. When overlocking, trim the seam allowances to 0.8 cm. The hem allowance is topstitched with a twin needle or on a coverstitch machine to maintain elasticity. You can also stitch the pieces directly on a 3- or 4-thread overlocker.

#4382
Belted Stand Collar Puff Sleeve Dress
#4380
Asymmetric Draped Cap Sleeve Peplum Dress

#4393
Dress Asymmetrical Collar Pleated Front Three Quarter Sleeves

#4378
Sleeveless Notched Lapel Tie-Waist Dress

#4394
Long Sleeve Asymmetric Draped Dress

#4396
Keyhole Mandarin Collar Contrast Panel Dress

#4375
Puffed Sleeve Paneled Dress with Front Folds

#4397
Lace Back Fitted Cap Sleeve Dress

Minerva Support
Online