Professional made-to-measure digital sewing patterns — PDF · PLT · DXF AAMA

Minervainervabeta
#4141
#4143

Lace Trim Gathered Henley Tank Top

Pattern #4142

A sleeveless women's top for knit fabric, hip length, with front and back yokes cut from a cotton companion fabric, gathers below both yokes and a short four-button placket at the centre front. The neckline and armholes are edged with cotton lace. Drafted to your own measurements. Recommended fabric: knit fabric with medium stretch, from natural or blended fibres, for the lower front and back; a cotton companion fabric for the yokes and placket.

Tech. Description

Lace Trim Gathered Henley Tank Top

A sleeveless women's top for knit fabric, hip length, with front and back yokes cut from a cotton companion fabric, gathers below both yokes and a short four-button placket at the centre front. The neckline and armholes are edged with cotton lace.

When To Wear

  • On its own in summer, with shorts, jeans or a light skirt.
  • Under a cardigan or an unbuttoned shirt in spring and early autumn.

Key Design Features

Silhouette: Close to the body, straight through the hips, sleeveless with wide shoulders.

Length: Hip length, straight hem turned up and topstitched.

Neckline: Rounded scoop neckline edged with lace, the lace attached and turned out, allowances topstitched 0.1 cm from the seam.

Front: Yoke cut in two halves from the companion fabric; the lower front is gathered between marks and joined to the yoke.

Closure: Short placket at the centre front, running from the neckline across the yoke seam into the lower front, cut in four pieces and interfaced, with four buttons; buttonholes on the right front.

Back: Straight back yoke from the companion fabric; the lower back is cut on the fold and gathered into the yoke.

Finishing: Armholes edged with lace in the same way as the neckline; yoke seams overlocked and pressed up.

Level Of Difficulty

Intermediate. A placket set into a cut with a clipped corner, gathered knit joined to a cotton yoke, lace edging on curved edges, buttonholes in knit fabric.

Fabric Recommendations

Knit fabric with medium stretch, from natural or blended fibres, for the lower front and back; a cotton companion fabric for the yokes and placket.

Additional Supplies

  • Fusible interfacing (placket)
  • 4 buttons
  • Cotton lace, 2–2.5 cm wide (approximate length is marked on the front pattern piece)

Cutter's Must

If the patterns have a double contour, they include seam allowances. If the contour is single, the patterns do not include seam allowances. Seam allowances: Hem allowance – 2 cm, lower placket edge allowance – 2 cm, all other seams – 1 cm. Attention! First, print out the paper patterns and lay them out on the fabric width (fabric width can be from 90 cm to 150 cm) to determine how much material you will need (do not forget to account for paired and symmetrical pieces).

From main fabric:

  • Lower Front – 1 piece
  • Lower Back – 1 piece on fold

From companion fabric:

  • Front Yoke – 2 pieces
  • Back Yoke – 1 piece
  • Placket – 4 pieces

From fusible interfacing:

  • Placket – 2 pieces

Sewing Instructions

When stitching pieces, pay attention to the notches - they must match!

  1. Fuse interfacing to the Plackets.
  2. Run a gathering stitch (loose tension) along the upper edges of the Lower Front and Lower Back between the marks, and gather.
  3. Stitch the Lower Front to the Front Yokes and the Lower Back to the Back Yoke. Overlock the seams and press them upwards.
  4. Place the Placket pieces right sides together in pairs and stitch along one long edge. Turn right side out and press. Overlock the other long edge of each placket. Stitch the plackets, by the overlocked edge, to the front opening. Clip into the corner of the front, stopping 1 mm short of the seam line. Turn the plackets to the right side, tucking their lower ends inside. Stitch the allowances of the front and the plackets together.
  5. Stitch the shoulder seams. Overlock the seams and press them towards the back.
  6. Overlock the neckline and armhole edges. Stitch the lace to the armhole. Turn it outwards and topstitch the allowances onto the top 0.1 cm from the seam. Turn under the ends of the neckline lace and stitch the lace to the neckline. Turn it outwards and topstitch the allowances onto the top 0.1 cm from the seam.
  7. Overlock the lower edge of the top, turn it to the wrong side and topstitch.
  8. Make the buttonholes on the right front. Sew the buttons onto the left front.

Features

Order Pattern

Standard Sizes

Individual Measurements

Please double-check the file format and paper size. Your pattern is drafted in exactly the format you select; a different format or paper size later is a new order.

Similar patterns

View all
Support

Minerva Support

Online
Support
Hi! I'm Minerva's AI assistant. What can I help you with?