Professional made-to-measure digital sewing patterns — PDF · PLT · DXF AAMA
A women's hip-length lined jacket with an asymmetric front closed by a separating zipper, a notched collar with wide lapels, princess seams and a lower section joined at the waist. Two zip pockets sit in the lower front. Drafted to your own measurements. Recommended fabric: thin coating fabrics of natural or blended fibres.
A women's hip-length lined jacket with an asymmetric front closed by a separating zipper, a notched collar with wide lapels, princess seams and a lower section joined at the waist. Two zip pockets sit in the lower front.
Silhouette: Fitted bodice shaped by princess seams, with a horizontal seam at the waist and a separate lower section that flares slightly over the hips.
Collar: Notched collar with wide lapels; the upper collar is set into the jacket neckline and the undercollar into the facing. A decorative snap is set at the end of each lapel.
Closure: Asymmetric separating zipper: one tape is caught in the left front princess seam, the other is stitched to the right front edge.
Sleeves: Two-piece set-in sleeves with an elbow seam, the cap eased into the armhole; shoulder pads.
Pockets: Two zip pockets in the lower front: the zipper is set under the edges of a cut opening, teeth showing, with a lining bag behind.
Back: Centre back seam and princess seams to the waist; the lower back is cut in one piece on the fold.
Lining: Full lining, joined to the hem of the body and sleeves.
Advanced. An asymmetric zipper set into a princess seam, zip pockets cut into the front, a notched collar between the jacket and the facing, two-piece sleeves and a bagged lining.
Thin coating fabrics of natural or blended fibres.
If the patterns have a double contour, seam allowances are included. If the contour is single, seam allowances are not included. Seam allowances: all seams 1 cm. Hem allowance for garment bottom and sleeve hem - 3 cm. Attention! First, print out the paper patterns and lay them out on the fabric width (fabric width can be from 90 cm to 150 cm) to determine how much material you will need (do not forget to account for paired and symmetrical pieces).
From main fabric:
From lining fabric:
From fusible interfacing:
Lining pieces are cut according to the main fabric pieces, minus the width of the back neckline facing and the right front facing.
When stitching pieces, pay attention to the notches - they must match! Attention! Markings on patterns are made on the right side!

#2752
Lapel Collar Bomber Jacket
#2754
Long Sleeve Cropped Jacket with Neckline Pleats
#2733
Bomber Jacket with Zippered Pockets and Chest Flaps
#2728
Round Neck Cropped Trimmed Jacket

#2774
Blazer Dress Asymmetric Pleated Hem
#2716
Wrap Pleated Blazer Dress
#2784
Raglan Sleeve Zippered Stand Collar Jacket
#2805
Summer Jacket

Minerva Support
Online