Gathered Front Puffed Sleeve Blouse

Fabric & Materials

FABRIC RECOMMENDATIONS: soft blouse fabrics made of natural or blended fibers. YOU ALSO NEED: 1 button. IF THE PATTERNS HAVE A DOUBLE CONTOUR, SEAM ALLOWANCES ARE INCLUDED. IF THE CONTOUR IS SINGLE, SEAM ALLOWANCES ARE NOT INCLUDED. SEAM ALLOWANCES: Hem allowance – 2.5 cm; all other seams – 1 cm. ATTENTION! FIRST, PRINT OUT THE PAPER PATTERNS AND LAY THEM OUT ON THE FABRIC WIDTH (fabric width can be from 90 cm to 150 cm) TO DETERMINE HOW MUCH MATERIAL YOU WILL NEED (don't forget to account for paired and symmetrical pieces). WHEN STITCHING PIECES, PAY ATTENTION TO THE NOTCHES - THEY MUST MATCH!

CUTTER'S MUST

• From main fabric:
  • Back yoke - 2 pieces
  • Back - 1 piece on fold
  • Front yoke - 1 piece
  • Front - 1 piece on fold
  • Front sleeve part – 2 pieces
  • Back sleeve part – 2 pieces

Sewing Instructions

1. Finish the center edges of the back yoke separately. Stitch the center seam of the back yoke from the slit mark to the bottom. Press seams open. Stitch a reinforcing line along the slit.
2. Stitch the shoulder seams of the back and front yokes, press allowances towards the back and finish.
3. Cut a bias strip 2.5 cm wide and 10 cm long for the loop. Fold the strip in half lengthwise, right sides together, and stitch 0.3 cm from the fold. Trim allowances close to the stitching, turn the strip right side out and straighten the loop. Adjust the loop length. Sew the loop to the left side of the back yoke.
4. Cut a bias binding 4 cm wide and a length equal to the neckline length + 4 cm. Fold the bias binding in half lengthwise, wrong sides together, and press. Place the binding with the neckline edge on the wrong! side, leaving tails, and stitch. Fold the binding to the right! side, clip the seams and topstitch along the fold onto the main piece. Press the seam. Alternatively, you can bind the neckline with bias binding (binding length is indicated on the back pattern piece). In this case, the neckline allowance should be trimmed to 0 cm.
5. Attach the back yoke to the back. Finish the allowance and press upwards.
6. Form and secure the pleats on the front. Attach the front to the yoke, press allowances upwards and finish.
7. Stitch the side seams, press allowances towards the back and finish.
8. Stitch the sleeve seam, press allowances towards the back part and finish. Finish the bottom edges of the upper and lower sleeve parts, press to the wrong side and topstitch. Lay the upper sleeve part over the lower part, aligning the notches, and secure at the sleeve cap.
9. Set the sleeves into the armholes, aligning the marks. Press and finish the allowances.
10. Hem the bottom of the garment by folding inwards 1 cm, then 1.5 cm, and topstitch.
11. Sew the button to the right side of the back yoke.