Embroidered Bridal Corset

Name: Embroidered Bridal Corset
Brand: Minerva Patterns
SKU: 2006
Price: 5.00 EUR
Availability: InStock

Pattern #2006

A women's boned halter corset top with a deep V-neck, a turn-down collar that fastens at the back of the neck, an open upper back and a separating zip at the centre back. Lace appliqué or embroidery decorates one side of the front. Drafted to your own measurements. Recommended fabric: dense satin, for the corset and its lining.

Tech. Description

Embroidered Bridal Corset

When To Wear

As a bridal top with a long skirt in satin or tulle.
For an evening event, with a full or straight skirt.

Key Design Features

Silhouette: Close-fitting, boned corset shaped by vertical seams on the front and back.

Length: Below the waist, with the front hem dipping to a point at the centre front.

Neckline: Halter neck with a deep V at the front; shoulders and upper back left bare.

Collar: Turn-down collar with pointed ends, closed at the back with 2 small buttons and hanging cord loops.

Sleeves: Sleeveless.

Front: Lace fabric, appliqué or embroidery sewn onto the finished front and beaded by hand.

Back: Low corset back with a separating zip in the centre back seam.

Finishing: Metal or plastic bones, 2 cm shorter than the seam, set into the bodice seams; all corset pieces fused with interfacing.

Lining: Satin is also recommended for the lining.

Level Of Difficulty

Intermediate. Boned seams, a fully interfaced corset, a separating zip in the centre back and a collar with button and cord-loop closure.

Fabric Recommendations

Dense satin, for the corset and its lining.

Additional Supplies

Separating zip
Metal or plastic boning
Lace appliqué or embroidery
Beads for hand embroidery
Fusible interfacing (all corset pieces)
Cord for the loops
2 small buttons

Cutter's Must

If the patterns have a double contour, they include seam allowances. If the contour is single, the patterns do not include seam allowances. Seam allowances: Seam allowance for the center back seam (for zipper insertion) of the garment - 2 cm. Other seams - 1 cm. Attention! First, print out the paper patterns and lay them out on the fabric width (fabric width should be at least 140 cm) to determine how much material you will need. Lace fabric or trim: Sew onto the finished front and hand-embroider with beads.

From satin:
- All corset pieces. Also recommended for use as lining.
From fusible interfacing:
- All corset pieces.

Sewing Instructions

When stitching pieces, pay attention to the notches - they must match! Try to observe the grain line direction.

Metal or plastic boning, 2 cm shorter than the seam length (for ease of processing), should be inserted into the bodice seams.
Zipper in the center back seam.
Back closure at the collar with 2 small buttons and cord loops.