Professional made-to-measure digital sewing patterns — PDF · PLT · DXF AAMA
A knee-length women's sheath dress with a centre front panel overlaid with lace, a double-layer flounce set into the left front princess seam, and short sleeves pleated at the top and gathered at the hem with elastic thread. Centre back zipper and vent. Drafted to your own measurements. Recommended fabric: silk fabrics from natural or blended fibres for the dress; lace fabric for the centre front overlay.
A knee-length women's sheath dress with a centre front panel overlaid with lace, a double-layer flounce set into the left front princess seam, and short sleeves pleated at the top and gathered at the hem with elastic thread. Centre back zipper and vent.
Silhouette: Close-fitting sheath shaped by princess seams at the front and back.
Length: Knee length.
Neckline: Round neckline finished with a fused facing; a narrow strap is caught in the neckline seam on the left front.
Sleeves: Short sleeves joined to the front and back between marks, extending up to the neckline; pleats at the upper edge and elastic thread stitched along the turned-up hem. The underarm section of the armhole is finished with 4 cm bias binding.
Front: Centre front cut on the fold from both main fabric and lace, the two layers handled as one. A flounce of two layers, stitched together, is caught in the left princess seam; its free end is folded into a loose pleat and held under the strap topstitched to the front.
Back: Centre back and side back pieces joined by princess seams; centre back seam with a zipper at the top and a lapped vent at the hem, interfaced and topstitched across the top.
Finishing: Seam allowances overlocked; hem turned up and topstitched.
Intermediate. Layering lace over a base fabric, a lapped back vent, a flounce inserted into a princess seam, and partial bias binding of the armholes.
Silk fabrics from natural or blended fibres for the dress; lace fabric for the centre front overlay.
If the patterns have a double contour, seam allowances are included. If the contour is single, seam allowances are not included. Seam allowances: allowance for the hem of the garment and sleeve hem – 2 cm, other allowances – 1 cm. Attention! First, print out the paper patterns and lay them out on the fabric width (fabric width can be from 90 cm to 150 cm) to determine how much material you will need. When stitching pieces, pay attention to the notches – they must match!
From main fabric:
From lace fabric:

#4400
Boat Neck Cap Sleeve Pleated A-Line Dress

#4402
Fitted Dress Gathered Sheer Yoke

#4399
V-Neck Cap Sleeve Pleated Sheath Dress

#4403
V-Neck Pintucked Midriff Midi Dress

#4404
Sleeveless Sheath Dress with Draped Front

#4397
Lace Back Fitted Cap Sleeve Dress

#4405
Fitted Guipure Collared Dress with Pleats

#4396
Keyhole Mandarin Collar Contrast Panel Dress

Minerva Support
Online