Fabric & Materials
FROM FUSIBLE INTERFACING: FACING, pocket FACING.
TIP: To ensure the material remains stretchy in areas with finished seams, stitch the cut pieces with a narrow zigzag or special stretchy stitch. To keep the bottom edge stretchy, the hem should be overlocked (serged) and then stitched using a twin needle. The same applies to finishing other edges of the garment that should not lose elasticity. These recommendations do not apply to industrial production.
CUTTER'S MUST
- From main fabric:
- 1. BACK PANEL – 1 QTY
- 2. Lower FRONT PANEL – 2 QTY
- 3. Upper FRONT PANEL – 2 QTY
- 4. Pocket – 2 QTY
- 5. Pocket FACING – 4 QTY
- 6. Hood – 2 QTY
- 7. Central part of hood – 1 QTY
- 8. Underlap – 2 QTY
- 9. SLEEVE – 2 QTY
- 10. CUFF – 2 QTY
- 11. Belt – 1 QTY
Sewing Instructions
- Fuse the underlap and pocket FACING with FUSIBLE INTERFACING.
- Attach the central part to the hood and overlock the SEAM ALLOWANCES. Mark and overlock the buttonholes on the front edge of the hood. Overlock the front edge of the hood, fold, and topstitch.
- Fold the pocket FACING pieces and stitch the upper edge. Turn the FACING right side out and press.
- Attach the pocket FACING to the pocket. Overlock the attachment SEAM ALLOWANCES.
- Mark the pocket placement on the lower FRONT PANEL and pin the pocket.
- Attach and overlock the lower FRONT PANEL to the upper FRONT PANEL. Remove pins.
- Stitch and overlock the shoulder SEAM ALLOWANCES, inserting TRIM STRIP. Stitch and overlock the side SEAM ALLOWANCES. Press the shoulder and side SEAM ALLOWANCES towards the BACK PANEL. Overlock the lower edge of the belt. Attach the belt.
- Fold the FRONT PANELs right sides together and align the edges, measure the length of the front edges. Attach the ZIPPER to the edge of the front opening. Fold the edges of the front opening at the ZIPPER section and press.
- Overlock the outer edge of the underlap. Place the underlap on the right side of the FRONT PANEL, face down, and stitch along the front edge line. Stitching is done from the FRONT PANEL side. Stitch the lower corner of the belt. Turn the front edges right side out, straighten the SEAM ALLOWANCES, and press. Topstitch the overlocked edge of the belt into the belt attachment SEAM ALLOWANCES.
- Insert the hood into the neckline. Overlock the insertion SEAM ALLOWANCES. Secure the underlaps to the shoulder SEAM ALLOWANCES with a 1 cm tack.
- Stitch the SLEEVE edge. Overlock and press the SEAM ALLOWANCES.
- Stitch the side SEAM ALLOWANCES of the CUFF. Fold the CUFF wrong side in along the middle.
- Attach the CUFFs to the bottom of the SLEEVE and overlock the upper edge of the CUFF together with the SLEEVE.
- Insert the SLEEVEs into the armhole according to the NOTCHES.
- Topstitch along the ZIPPER at a distance of 0.5 cm. Thread the cord through the hood buttonholes.
