Professional made-to-measure digital sewing patterns — PDF · PLT · DXF AAMA

Minervainervabeta
#4135
#4137

Cowl Neck Drawstring Dress Flap Pockets

Pattern #4136

A knee-length women's dress for knit fabric, with a draped cowl neckline, short cut-on sleeves gathered with elastic thread along the shoulder, a drawstring casing at the waist and two box-pleated patch pockets with buttoned flaps. Drafted to your own measurements. Recommended fabric: well-draping knit of medium stretch, from natural or blended fibres.

Tech. Description

Cowl Neck Drawstring Dress Flap Pockets

A knee-length women's dress for knit fabric, with a draped cowl neckline, short cut-on sleeves gathered with elastic thread along the shoulder, a drawstring casing at the waist and two box-pleated patch pockets with buttoned flaps.

When To Wear

  • Everyday wear in spring and summer, with flat sandals or trainers.
  • Travel and weekends: the knit fabric and tie waist make it easy to wear all day.

Key Design Features

Silhouette: Blouson bodice drawn in at the waist by a tie, with a straight skirt below.

Length: To the knee.

Neckline: Cowl drape on the front, cut in one with the front; neck edges overlocked, turned in and topstitched.

Sleeves: Short sleeves cut in one with the bodice, gathered with elastic thread from a mark on the shoulder seam to the sleeve edge, and finished with a double-folded cuff. A shoulder strap with a button is caught into each cuff seam.

Waist: A separate casing topstitched around the waist on the front and back, with 3 cm twill tape threaded through and tied at the centre front.

Pockets: Patch pockets on the front skirt, each with a box pleat, and a buttoned flap above, topstitched 0.7 cm from the edge.

Back: Centre back seam running the full length.

Finishing: Hem and neckline overlocked, turned and topstitched; twin needle or coverstitch recommended to keep the stretch.

Level Of Difficulty

Intermediate. Sewing stretch knit, shirring with elastic thread, two-layer flaps with buttonholes, pleated patch pockets and a topstitched casing.

Fabric Recommendations

Well-draping knit of medium stretch, from natural or blended fibres.

Additional Supplies

  • Twill tape 3 cm wide (length marked on the front pattern piece)
  • 4 buttons
  • Elastic thread
  • Small piece of fusible interfacing for the buttonhole area on the outer flaps

Cutter's Must

If the patterns have a double contour, they include seam allowances. If the contour is single, the patterns do not include seam allowances. Seam allowances: hem allowance and neckline allowance for back and front – 1.5 cm, casing contour – 0 cm, top edge of pocket – 2 cm, other edges of pocket and flap – 1 cm, other seams 0.8 cm. Attention! First, print out the paper patterns and lay them out on the fabric width (fabric width can be from 90 cm to 150 cm) to determine how much material you will need. When stitching pieces, pay attention to the notches - they must match! Inscriptions on the patterns are on the right side!

  • Back – 2 pieces
  • Front – 1 piece on fold
  • Cuff – 2 pieces
  • Shoulder Strap – 4 pieces
  • Flap – 4 pieces
  • Pocket – 2 pieces
  • Casing – 1 piece

Tip: Knit fabric pieces are stitched with a special elastic or narrow zigzag stitch. The hem allowance is topstitched with a twin needle or on a coverstitch machine to maintain elasticity. You can also stitch pieces directly on a 3- or 4-thread overlocker.

Sewing Instructions

  1. Stitch the centre back seam of the Back. Press the seam allowances to the left side and overlock.
  2. Lay a box pleat on each Pocket and tack the pleat depths together. Press the top allowance of the Pockets to the wrong side, fold under and topstitch. Press the side and bottom allowances of the Pockets to the wrong side. Place the Pockets on the Front according to the markings and topstitch.
  3. Interface the buttonhole area on the outer Flaps. Place the Flap pieces right sides together in pairs and stitch around, leaving the upper edge open. Trim the corner allowances of the Flaps and turn right side out. Straighten the seams and press, topstitch 0.7 cm from the edge. Overlock the open edge of the Flaps and make the buttonholes. Stitch the Flaps to the Front above the Pockets, turn them down and topstitch. Sew buttons on the Pockets to match the buttonholes.
  4. Stitch the shoulder and side seams, press the allowances towards the back and overlock.
  5. Press the short edges of the Casing 3 cm and the long edges 1 cm to the wrong side, place the Casing around the waist on the Front and Back and topstitch along the markings, slightly stretching the lower edge of the Casing.
  6. Place the Shoulder Strap pieces right sides together in pairs and stitch around, leaving one short edge open. Trim the corner allowances and turn right side out. Straighten the seams and press, topstitch 0.1 cm from the edge.
  7. From the mark on the shoulder seam to the lower edge of the sleeve, stitch with elastic thread.
  8. Stitch each Cuff into a ring. Turn the pieces right side out, fold in half lengthwise right side out and press. Stitch the Cuffs to the sleeves, placing the open end of a Shoulder Strap under the Cuff at the shoulder. Press the seam. Turn the Shoulder Strap onto the right side and sew on a button.
  9. Overlock the bottom edge of the garment and the neckline edges. Press to the wrong side and topstitch.
  10. Fold the ends of the twill tape twice by 0.5 cm and topstitch. Thread the tape through the Casing.

Features

Order Pattern

Standard Sizes

Individual Measurements

Please double-check the file format and paper size. Your pattern is drafted in exactly the format you select; a different format or paper size later is a new order.

Similar patterns

View all
Support

Minerva Support

Online
Support
Hi! I'm Minerva's AI assistant. What can I help you with?