Faux Fur Flounced Collared Jacket

CUTTER'S MUST

• From faux fur:
1. Yoke with FLOUNCE - 1 QTY
2. Lower part with FLOUNCE - 1 QTY
3. FRONT PANEL yoke - 2 QTY
4. Lower FRONT PANEL part - 2 QTY
5. SLEEVE – 2 QTY
6. Lower COLLAR – 1 QTY
7. Upper COLLAR - 1 QTY
8. FACING – 2 QTY
• From LINING fabric:
1. Yoke with FLOUNCE - 1 QTY
2. Lower part with FLOUNCE - 1 QTY
3. FRONT PANEL yoke - 2 QTY
4. Lower FRONT PANEL part - 2 QTY
5. SLEEVE – 2 QTY
6. Upper pocket bag – 2 QTY
7. Lower pocket bag – 2 QTY

ATTENTION: The FRONT PANEL yoke and lower FRONT PANEL parts are cut without considering the width of the FACING.

Sewing Instructions

1. Attach the FACING to the lower pocket bag. Place the pocket bag with the FACING on the right side of the BACK PANEL according to the NOTCHES, place the upper pocket bag on the FRONT PANEL right side down and attach. Fold back the SEAM and topstitch it onto the pocket bag.
2. Attach the BACK PANEL yoke to the lower BACK PANEL part.
3. Attach the FRONT PANEL yoke to the lower FRONT PANEL parts.
4. Stitch the shoulder SEAM ALLOWANCES of the jacket.
5. Fold the COLLAR pieces right sides together and stitch along the ends and the outer edge. Turn the COLLAR right side out. Baste the COLLAR into the neckline.
6. Set the SLEEVES into the armholes.
7. Stitch the SLEEVE edge and the side edge together with the pocket bags in one SEAM.
8. The LINING assembly is similar to the main garment assembly: attach the yoke to the BACK PANEL, attach the FRONT PANEL yoke to the FRONT PANEL. Stitch the side SEAM ALLOWANCES and SLEEVE SEAM ALLOWANCES, leaving an opening in the front right SLEEVE SEAM for subsequent turning out. Stitch the shoulder SEAM ALLOWANCES from the armhole edges for approximately 5 cm. Attach the FRONT PANEL LINING to the FACING edges. Stitch the shoulder SEAM ALLOWANCES to the end. Set the SLEEVES into the armholes.
9. Fold the LINING and FACINGS with the jacket right sides together and stitch the neckline. Attach the lower edges of the FACINGS to the FRONT PANEL strictly along the marked hemline. Trim the SEAM ALLOWANCES of the lower corners of the front edge.
10. Attach the LINING to the bottom of the jacket and the bottom of the SLEEVES. Turn the jacket right side out through the opening in the SLEEVE. Stitch the opening in the SLEEVE.
11. Sew fur hooks under the edge of the right FRONT PANEL. Overlap the right FRONT PANEL over the left FRONT PANEL, aligning the center lines, and mark the positions for the loops. Sew the loops to the left FRONT PANEL.