Pattern

CUTTER'S MUST

• From main fabric:
• FRONT PANEL - QTY 2
• BACK PANEL - QTY 2
• Back FACING – QTY 1 on fold
• Front FACING – QTY 2
• From FUSIBLE INTERFACING: back FACING, front FACING.

Sewing Instructions

1. Reinforce FACINGS with fusible interfacing (Heat-adhesive interfacings are pressed onto the wrong side of the piece with a hot iron).
2. Stitch darts, press dart allowances towards the center.
3. Sew side and inseam seams. Overcast SEAM ALLOWANCES and press open.
4. Stitch the center front seam from the fastener mark downwards and, without breaking the stitch, sew the center back seam.
5. ZIPPER fastener. Press the one-piece FACINGS of the fastener to the wrong side: on the right - along the center front line, on the left - 1 cm from the center front line (= allowance for the fastener).
6. Stitch the ZIPPER under the edge of the fastener allowance (left side) to the edge, positioning the teeth close to the fold.
7. Pin the slit, aligning the center front lines.
8. Stitch the free tape of the ZIPPER to the FACING of the right side of the fastener, without catching the fabric of the front pant leg.
9. Topstitch the right front pant leg along the fastener according to the marking, catching the FACING.
10. Stitch the front and back FACINGS at the side edges. Press allowances open. Overcast the bottom edge.
11. Place FACINGS with the upper edge of the pants right sides together and stitch. Turn right side out, secure the short sides and topstitch the upper edge at 1 mm.
12. Press the pant hem allowance inwards, turn under the raw edges and topstitch.
13. On the right side of the front panel, overcast a buttonhole, on the left - sew on a button.